Into the Woods Mittens | Knitting pattern and knitting kits
Say hello to Julie Peng's latest creation, the Into the Woods mittens, made with our Hagrid yarn ♡.
You have the option to purchase the pattern only or the knitting kit, which contains both the yarn and the pattern needed to knit this project!
Here is what you need to knit this project:
- The Into the Woods Mittens knitting pattern (sent as a PDF numeric file) - The pattern is included when you purchase a kit.
- Biscotte Yarns – HAGRID [85% merino sw, 15% nylon, 100 m par 25 g] - 1 skein - shown in Kalamata & Vitamine C
To complete this knitting project, you will require these additional accessories along with the knitting kit:
-
Circular needle
PRINCIPAL: needle of 4.5 mm (or the size required to obtain the gauge)
RIBS: needle of 4 mm (or the size required to obtain the gauge) - Tapestry needle
- Stitch markers (3)
- Stitch Holder
SIZES AVAILABLE IN THE PATTERN - Adult S/M (M/L)
Finished Measurements:
- circumference: 17.75 (19) cm | [7 (7.5) in]
- length: 26.5 (28) cm | [10.5 (11) in]
GAUGE: 18 sts x 25 rounds = 10 cm [4 in] in st st after blocking using larger needles.
NOTE: These mittens are knitted in the round from the cuff up with no seams. The knitted fabric was intended to be a little tight and worn a little snug for extra warmth and coziness. If you prefer to wear your mittens a little loose, you can try using needles one size up or use a wider blocker (but be careful not to stretch them out too much!).